MODEL H8027
Heavy-Duty Bar Clamp Heads
INSTRUCTION SHEET
To assemble:
Note: Make sure holes are at least 3 in. from the
ends of the board so that the board will not split when
stressed.
1. Select a dry, straight wooden board of the dimensions
shown in Figure 1.
3. Using the hex bolts and nuts provided, mount the two
bar clamp heads (see Figure 3).
2. Drill as many 7⁄16 in. holes as desired along the length of
the board, at least 3 in. apart and 3⁄4 in. on center from
the top of the board (see Figure 2).
If you need help with your new bar clamp heads, call our
Tech Support at: (570) 546-9663.
����������
�����
����
����
���
������
��
Figure 1. Wood dimensions.
Figure 2. Drilled hole dimensions.
Figure 3. Bar clamp heads mounted.
COPYRIGHT © AUGUST, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TS8466 PRINTED IN CHINA
|